See Answer

Add Answer +20 Points

Community Answer

See all the answers with 1 Unlock

Get 4 Free Unlocks by registration

Get 4 Free Unlocks by registration

) The largest deviation in Table 3.3 is 5.6k ohms resistor, As we have seen the measured value is deviated by 2.67% to the Actual value and this is the highest deviation listed in the table. tAs an end-user, there is no practical way to measure the tolerance of resistors. The value of tolerance is almost always marked on the part or traceable by markings to a data-sheet. tIf you were determined to get some tolerance rating, you could take a batch of similar rated parts, like 60 pcs or 150pcs . You would measure and write down each measured value and then apply some basic statistical analysis to determine the upper and lower limits as well as the average and the standard deviation. Then you would have some finite numbers for ... See the full answer